Home › BODY ELECTRICAL › LIGHTING › FOG LIGHT ASSEMBLY

FOG LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT FENDER LINER LH


    B130315
  1. Using a clip remover, remove the clip.

  1. Partially remove the fender liner.

    HINT:
    It is not necessary to fully remove the fender liner. Partially remove it so that the bumper cover can be removed in a later step.



2. REMOVE FRONT FENDER LINER RH

HINT:
Use the same procedure described for the LH side.



3. REMOVE FRONT BUMPER COVER


B130316E01
  1. Put protective tape under the front fender.

  1. Using a clip remover, remove the 3 clips.

  1. Remove the 2 radiator grille protectors and 4 screws.

  1. Detach the 8 claws.



    B078079E02
  1. Detach the 4 claws and remove the bumper cover.

    1. Hold the front bumper cover on its upper and lower parts with your hands as shown in the illustration.

    2. Pull up the front bumper cover's lower part while holding its upper part securely.

      NOTICE:
      1. The claw will not disengage unless the front bumper cover's upper part is securely held.
      2. Do not forcibly pull up the front bumper. This will deform the claw.

  1. w/ Fog light:
    Disconnect the 2 fog light connectors.



4. REMOVE RADIATOR GRILLE LOWER LH


    B073577E01
  1. Using a screwdriver, detach the 4 claws and remove the grille.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE FOG LIGHT UNIT LH


    E074103E02
  1. Detach the 3 claws and push the fog light unit towards the front of the vehicle.

  1. Remove the fog light bulb from the fog light unit.