Home › BODY ELECTRICAL › LIGHTING › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. INSTALL REAR COMBINATION LIGHT ASSEMBLY LH


I039795E01
  1. Install the 3 bulbs and bulb sockets to the rear combination light.

  1. Connect the connector and install the rear combination light.

  1. Slide the 2 pins towards the back of the vehicle to install them.

  1. Install the 2 nuts.



2. INSTALL REAR COMBINATION LIGHT SERVICE COVER LH


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.