Home › BODY ELECTRICAL › LIGHTING › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE REAR COMBINATION LIGHT SERVICE COVER LH


3. REMOVE REAR COMBINATION LIGHT ASSEMBLY LH


    I039795E01
  1. Remove the 2 nuts.

  1. Slide the 2 pins towards the back of the vehicle to remove them.

  1. Disconnect the connector and remove the rear combination light.

  1. Remove the 3 bulb sockets and 3 bulbs from the rear combination light.