Home › BODY ELECTRICAL › LIGHTING › LICENSE PLATE LIGHT ASSEMBLY

LICENSE PLATE LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. INSTALL LICENSE PLATE LIGHT LENS
  1. Install the bulb to the socket.

  1. Install the bulb/socket unit to light.

  1. Connect the connector.



    B136393E01
  1. Install the light as shown in the illustration.



2. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY


    B067629E01
  1. Install the back door opener switch to the garnish with the 2 screws.



  1. Attach the 2 clips to install the garnish.


    B133842E01

  1. Install the 4 nuts.

  1. Connect the back door opener switch connector.



3. INSTALL BACK DOOR TRIM BOARD ASSEMBLY


B075175E04
  1. Attach the 11 clips to install the lower trim board.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.