Home › BODY ELECTRICAL › LIGHTING › LICENSE PLATE LIGHT ASSEMBLY

LICENSE PLATE LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. REMOVE BACK DOOR TRIM BOARD ASSEMBLY
  1. Using a screwdriver, detach the 11 clips and remove the lower trim board.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
  1. Disconnect the back door opener switch connector.



  1. Remove the 4 nuts.


    B133842E01

  1. Using a screwdriver, detach the 2 clips and remove the garnish (with back door opener switch).

    HINT:
    Tape the screwdriver tip before use.



    B067629E01
  1. Remove the 2 screws and back door opener switch from the garnish.



3. REMOVE LICENSE PLATE LIGHT ASSEMBLY


    E074104E03
  1. Remove the light as shown in the illustration.

  1. Disconnect the connector.

  1. Remove the bulb/socket unit from the light.

  1. Remove the bulb from the socket.