Home › BODY ELECTRICAL › LIGHTING › HIGH MOUNTED STOP LIGHT ASSEMBLY

HIGH MOUNTED STOP LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE BACK DOOR TRIM UPPER PANEL ASSEMBLY


    B077067E03
  1. Using a screwdriver, detach the 5 clips and remove the upper trim board.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE CENTER STOP LIGHT ASSEMBLY


    E071103E01
  1. Disconnect the connector.

  1. Tie a string around the center stop light assembly cord.



    E071102E01
  1. Remove the 2 screws and the center stop light assembly.

    NOTICE:
    The string will be used when installing, so leave the string as it is inside the back door.