HEADLIGHT DIMMER SWITCH > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 2 STEERING WHEEL COVER LOWER |
| 3. REMOVE NO. 3 STEERING WHEEL COVER LOWER |
| 4. REMOVE STEERING PAD ASSEMBLY |
![]() |
Straighten the front wheels.
Using a T30 "TORX" socket, loosen the 2 screws until the groove along each screw circumference catches on the screw case.
![]() |
Pull out the steering pad from the steering wheel and support the steering pad with one hand as shown in the illustration.
Using a screwdriver, disconnect the 2 airbag connectors.
Disconnect the horn connector and remove the steering pad.
| 5. REMOVE STEERING WHEEL ASSEMBLY |
![]() |
Remove the nut and put matchmarks on the steering wheel and steering main shaft.
Using SST, remove the steering wheel.
| 6. REMOVE STEERING COLUMN COVER |
![]() |
Detach the 4 claws and remove the 3 screws. Then remove the steering column lower cover and the steering column upper cover.
| 7. REMOVE SPIRAL CABLE SUB-ASSEMBLY |
![]() |
Disconnect the airbag connector.
Detach the 3 claws and remove the spiral cable.
| 8. REMOVE WIPER AND WASHER SWITCH ASSEMBLY |
![]() |
Disconnect the connector.
Push and disengage the claw shown in the illustration and remove the windshield wiper switch.
| 9. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY |
![]() |
Disconnect the connectors.
Remove the band clamp as shown in the illustration.
![]() |
Detach the claws and remove the headlight dimmer switch.