HEIGHT CONTROL SENSOR > INSTALLATION |
| 1. INSTALL HEIGHT CONTROL SENSOR SUB-ASSEMBLY |
![]() |
Connect the connector.
Connect the height control sensor link to the rear axle beam with the nut.
Install the height control sensor with the 2 bolts.
| 2. PERFORM INITIALIZATION |
Perform initialization (Click here).
| 3. ADJUST HEADLIGHT AIM ONLY |
Prepare the vehicle by performing the following.
![]() |
Prepare a piece of thick white paper (draw base lines).
V line (vehicle center position).
Draw a vertical line down the center of the paper to align with the center of the vehicle.
H line (headlight height).
Draw a horizontal line across the paper so that it is at the same height as the center mark of the low-beam light on the vehicle.
V LH line, V RH line (center mark position of right and left headlights).
Draw vertical lines on the left and right sides of the paper so that they line up with the center mark on the low-beam lights on the vehicle.
![]() |
Check headlight aim
Align the paper and vehicle.
Start the engine.
![]() ![]() |
Turn on the headlight and check that the aim is within the specified range shown in the illustration.
![]() |
Adjust the aim in the vertical direction:
Using a screwdriver, adjust the headlight aim into the specified range by turning aiming screw A.