Home › BODY ELECTRICAL › LIGHTING › HEIGHT CONTROL SENSOR

HEIGHT CONTROL SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE HEIGHT CONTROL SENSOR SUB-ASSEMBLY


E071123E01
  1. Disconnect the connector.

  1. Remove the nut and disconnect the height control sensor link from the rear axle beam.

  1. Remove the 2 bolts and height control sensor.