Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT LEVELING ECU

HEADLIGHT LEVELING ECU > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


B074051E02
  1. While pushing in the sides of the glove compartment door as indicated by the arrows in the illustration, open the door to release it from the 2 stoppers.

  1. Open the door until it is horizontal.



    B074052E02
  1. Pull the glove compartment door toward the rear of the vehicle to detach the 2 hinges and remove the glove compartment door.



3. REMOVE ECM


A087532E01
  1. Disconnect the 4 ECM connectors.

  1. Disconnect the 4 hybrid vehicle control ECU connectors.



    A087535E01
  1. Remove the 2 nuts and bolt, and ECM with bracket.



    A087475E01
  1. Remove the 2 nuts and ECM.



    A087476E01
  1. Remove the 6 screws and 3 No. 1 ECM brackets.



    A087477E01
  1. Remove the 4 screws and 2 No. 2 ECM brackets.



    A087478E01
  1. Remove the 2 screws and No. 3 ECM bracket.



4. REMOVE HEADLIGHT LEVELING ECU


I039784E01
  1. Disconnect the ECU connector.

  1. Remove the bolt and ECU.