Home › ENGINE › 1NZ-FXE EMISSION CONTROL › PURGE FLOW SWITCHING VALVE

PURGE FLOW SWITCHING VALVE > REMOVAL

for Preparation Click here



1. REMOVE REAR NO. 2 FLOOR BOARD


    A088353E01
  1. Unlock the 2 washer tank cover knobs, and then remove the rear floor board.



2. REMOVE REAR DECK FLOOR BOX


    A088354E01
  1. Remove the rear deck floor box from the vehicle.



3. REMOVE REAR NO. 3 FLOOR BOARD


    A088355E02
  1. Detach the 4 claws, and then remove the floor board.



4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



5. REMOVE PRESSURE SWITCHING VALVE


    A087519E01
  1. Disconnect the pressure switching valve connector.

  1. Disconnect the 3 canister hoses from the pressure switching valve.



    A087520E01
  1. Remove the bolt, then remove the pressure switching valve.