Home › ENGINE › 1NZ-FXE EMISSION CONTROL › FUEL TANK PRESSURE SENSOR

FUEL TANK PRESSURE SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK FUEL TANK PRESSURE SENSOR


    A088404E02
  1. Inspect the voltage.

    1. Turn the power switch ON (IG).

    2. Measure the voltage between the terminals.

      Standard voltage:
      Tester Connection
      Specified Condition
      1 - 3
      4.5 to 5.5 V

    3. Remove the fuel tank cap.



    4. A088235E02
    5. Measure the voltage between the terminals.

      Standard voltage:
      Tester Connection
      Specified Condition
      2 - 3
      3.0 to 3.6 V

    6. Reinstall the fuel tank cap.

    7. Turn the power switch OFF.