Home › HYBRID SYSTEM › HYBRID TRANSMISSION / TRANSAXLE › HYBRID VEHICLE TRANSAXLE

HYBRID VEHICLE TRANSAXLE > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT SPEED SENSOR (RESOLVER)


A077571E01


    A077568E05
    A077568E04
  1. Using an ohmmeter, measure the resistance between the terminals.

    Standard resistance:
    Tester Connection
    Specified Condition
    A1 (GCS) - A4 (GCSG)
    12.6 to 16.8 Ω
    A2 (GSN) - A5 (GSNG)
    12.6 to 16.8 Ω
    A3 (GRF) - A6 (GRFG)
    7.65 to 10.2 Ω
    B1 (MRF) - B4 (MRFG)
    7.65 to 10.2 Ω
    B2 (GSN) - B5 (MSNG)
    12.6 to 16.8 Ω
    B3 (MCS) - B6 (MCSG)
    12.6 to 16.8 Ω
    All of terminals above - Transaxle housing
    10 kΩ or higher

    If the results are not as specified, replace the hybrid vehicle transaxle assembly.



2. INSPECT TEMPERATURE SENSOR


A083656E02


    A077568E06
    A125180E01
  1. Using an ohmmeter, measure the resistance between the terminals.

    Standard resistance:
    Tester Connection
    Specified Condition
    C1 (MMT) - C4 (MMTG)
    87.3 to 110.5 kΩ at 10°C (50°F)
    23.8 to 28.5 kΩ at 40°C (104°F)
    C3 (OMT) - C6 (OMTG)
    87.3 to 110.5 kΩ at 10°C (50°F)
    23.8 to 28.5 kΩ at 40°C (104°F)
    All of terminals above - Transaxle housing
    1 MΩ or higher

    HINT:
    The standard varies according to the sensor temperature. If the results are not as specified, replace the hybrid vehicle transaxle assembly.