Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter

for Preparation Click here


DESCRIPTION

This circuit is necessary for the ASL (Auto Sound Levelizer) built into the radio receiver. Speed signals are received from the combination meter and used for the ASL.
The ASL function automatically adjusts the sound data in order to enable hearing the clear audio even when vehicle noise increases (as vehicle noise increases, the volume is turned up, etc.).

WIRING DIAGRAM


E107202E04


INSPECTION PROCEDURE

1.OPERATION OF SPEEDOMETER
  1. Drive the vehicle and check if the function of the speedometer on the combination meter is normal.

    OK:
    Actual vehicle speed and the speed indicated on the speedometer are the same.

    HINT:
    The vehicle speed sensor is functioning normally when the indication on the speedometer is normal.



NG
GO TO METER / GAUGE SYSTEM
OK


2.CHECK RADIO RECEIVER (SPD VOLTAGE)


    E107234E01
  1. Disconnect the R5 receiver connector.



  1. Measure the voltage.

    1. Jack up either one of the drive wheels.

    2. Move the shift lever to the neutral position.

    3. Turn the power switch ON (IG).



    4. E110855E01
    5. Measure the voltage between terminal SPD of the radio receiver and body ground when the drive wheels are turned slowly.

      OK:
      Voltage pulses as shown in the illustration.



OK
REPLACE RADIO RECEIVER
NG


3.CHECK WIRE HARNESS (COMBINATION METER - RADIO RECEIVER)


    E107206E01
  1. Disconnect the R5 receiver connector.

  1. Disconnect the C10 meter connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    R5-3 (SPD) - C10-13
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.CHECK WIRE HARNESS (RADIO RECEIVER - BODY GROUND)


    E107195E03
  1. Disconnect the R5 receiver connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    R5-3 (SPD) - Body ground
    10 kΩ or higher

    HINT:
    If the resistance between terminal SPD and body ground is less than 10 kΩ, there may be a short in a wire harness, connector, or an ECU that is connected to the SPD signal wire.



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE RADIO RECEIVER