Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DESCRIPTION
  1. Air conditioning system data and the Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use Techstream to check for malfunctions and perform troubleshooting.


CHECK DLC3
The vehicle's ECM uses the ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.
If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.
E117124E04

Symbols (Terminal No.)
Terminal Description
Condition
Specified Condition
SIL (7) - SG (5)
Bus "+" line
During transmission
Pulse generation
CG (4) - Body ground
Chassis ground
Always
Below 1Ω
SG (5) - Body ground
Signal ground
Always
Below 1Ω
BAT (16) - Body ground
Battery positive
Always
11 to 14 V
CANH (6) - CANL (14)
HIGH-level CAN bus line
Power switch OFF*
54 to 67 Ω
CANH (6) - Battery positive
HIGH-level CAN bus line
Power switch OFF*
1 MΩ or higher
CANH (6) - CG (4)
HIGH-level CAN bus line
Power switch OFF*
3 MΩ or higher
CANL (14) - Battery positive
LOW-level CAN bus line
Power switch OFF*
1 MΩ or higher
CANL (14) - CG (4)
LOW-level CAN bus line
Power switch OFF*
3 MΩ or higher

NOTICE:
*: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the power switch, any other switches or the doors.

HINT:
Connect the cable of Techstream to the DLC3, turn the power switch ON (IG) and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.
  1. If communication is normal when the tester is connected to another vehicle, inspect the DLC3 of the original vehicle.
  1. If communication is still not possible when the tester is connected to another vehicle, the problem may be in the tester itself. Consult the Service Department listed in the tester's instruction manual.