Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM

REAR VIEW MONITOR SYSTEM > Display Signal Circuit between Multi-display and Television Camera Assembly

for Preparation Click here


DESCRIPTION

This is the display signal circuit of the television camera.

WIRING DIAGRAM


INSPECTION PROCEDURE


E142508E01

1.CHECK TELEVISION CAMERA ASSEMBLY


    E126485E03
    E119731E02
  1. Check the waveform of the camera using an oscilloscope.

    OK:
    Waveform is as shown in the illustration.

    Item
    Content
    Tester Connection
    CV+ (T13-2) - CV- (T13-1)
    Tool Setting
    0.2 V/DIV., 0.2 μsec./DIV.
    Condition
    Power switch ON (IG), shift lever R position



NG
REPAIR TELEVISION CAMERA ASSEMBLY
OK


2.CHECK WIRE HARNESS (MULTI-DISPLAY - TELEVISION CAMERA)


    E126424E05
  1. Disconnect the M14 display connector.

  1. Disconnect the T13 camera connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    M14-29 (CA+) - T13-4 (CB+)
    Below 1 Ω
    M14-30 (CGND) - T13-3 (CGND)
    Below 1 Ω
    M14-27 (V+) - T13-2 (CV+)
    Below 1 Ω
    M14-28 (V-) - T13-1 (CV-)
    Below 1 Ω
    M14-29 (CA+) - Body ground
    10 kΩ or higher
    M14-27 (V+) - Body ground
    10 kΩ or higher
    M14-28 (V-) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE