DTC P0AE0-228 Hybrid Battery Negative Contactor Control Circuit High |
DTC P0ADF-229 Hybrid Battery Negative Contactor Control Circuit Low |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P0AE0 | 228 | Open or +B short in No. 3 system main relay circuit |
|
| P0ADF | 229 | GND short in No. 3 system main relay circuit |
|
| Related DTCs | P0AE0 (INF 228): Rationality (cont3 malfunction) |
| Required sensor / components | No. 3 system main relay |
| Frequency of operation | Continuous |
| Duration | TOYOTA's intellectual property |
| MIL operation | 1 driving cycle |
| Sequence of operation | None |
| The monitor will run whenever the following DTCs are not present | TOYOTA's intellectual property |
| Other conditions belong to TOYOTA's intellectual property | - |
| No. 3 system main relay circuit | Short |
| No. 3 system main relay | DTC P0AE0 (INF 228) is not detected |
| 1.INSPECT NO. 3 SYSTEM MAIN RELAY |
Inspect the No. 3 system main relay .
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - NO. 3 SYSTEM MAIN RELAY) |
Turn the power switch OFF.
Remove the service plug grip .
![]() |
Disconnect the H16 HV control ECU connector.
![]() |
Disconnect the S22 No. 3 system main relay connector.
Turn the power switch ON (IG).
Measure the voltage between the terminal of the HV control ECU connector and body ground.
| Tester Connection | Specified Condition |
| CON3 (H16-3) - Body ground | Below 1 V |
Turn the power switch OFF.
Measure the resistance between the wire harness side connectors.
| Tester Connection | Specified Condition |
| CON3 (H16-3) - CON3 (S22-3) | Below 1 Ω |
| Specified Connection | Specified Condition |
| CON3 (H16-3) or CON3 (S22-3) - Body ground | 10 kΩ or higher |
Reconnect the No. 3 system main relay connector.
Reconnect the HV control ECU connector.
Reinstall the service plug grip .
|
| ||||
| OK | ||
| ||