Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING RESET SWITCH

TIRE PRESSURE WARNING RESET SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


B074044E02
  1. Detach the 2 claws and 4 clips, and remove the instrument panel register.



3. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER


B074045E02
  1. Remove the 2 screws.

  1. Disconnect the hood lock control cable.

  1. Detach the 4 claws and 5 clips.

  1. Disconnect all connectors and remove the instrument panel finish panel.



4. REMOVE TIRE PRESSURE WARNING RESET SWITCH


    C151917E01
  1. Disengage the 2 claws and remove the tire pressure warning reset switch from the instrument panel finish panel sub-assembly lower.