Home › BODY ELECTRICAL › WIPER AND WASHER › WIPER RELAY

WIPER RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT WINDSHIELD WIPER RELAY ASSEMBLY


    E065930E04
  1. Operation check

    1. Connect the voltmeter positive (+) lead to terminal 4 (LM) of the connector, and the voltmeter negative (-) lead to terminal 6 (LS).

    2. Connect the positive battery (+) lead to terminal 3 (+B) of the connector, and the negative battery (-) lead to terminal 6 (LS). Measure the voltage between terminals 4 (LM) and 6 (LS).

      Standard voltage:
      10 to 14 V