Home › BODY ELECTRICAL › LIGHTING › MAP LIGHT ASSEMBLY

MAP LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL MAP LIGHT BULB
  1. Install the bulb to the map light.



2. INSTALL MAP LIGHT ASSEMBLY
  1. Connect the map light connector.



    B076771E03
  1. Attach the 4 clips to install the map light.

  1. Install the 2 screws.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.