Home › BODY ELECTRICAL › LIGHTING › MAP LIGHT ASSEMBLY

MAP LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE MAP LIGHT ASSEMBLY


    B076771E02
  1. Remove the 2 screws.

  1. Using a moulding remover, detach the 4 clips and remove the map light.

  1. Disconnect the map light connector.



3. REMOVE MAP LIGHT BULB
  1. Remove the bulb from the map light.