Home › BODY ELECTRICAL › LIGHTING › ROOM LIGHT ASSEMBLY

ROOM LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE ROOM NO. 1 LIGHT ASSEMBLY


    B076772E03
  1. Using a screwdriver, detach the 4 claws and remove the room light lens.

    HINT:
    Tape the screwdriver tip before use.



    B073597E02
  1. Using a screwdriver, detach the 4 claws and remove the room light.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the room light connector.



3. REMOVE ROOM NO. 1 LIGHT BULB
  1. Remove the bulb from the room No. 1 light assembly.