Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT RELAY

HEADLIGHT RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT RELAY (Marking: H-LP)


    B112776E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.



2. INSPECT NO. 2 HEADLIGHT RELAY (Marking: DIM)


    B083458E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 4
    Below 1 Ω
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)
    3 - 4
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.