Home › SERVICE SPECIFICATIONS › SERVICE SPECIFICATIONS › 1NZ-FXE ENGINE CONTROL SYSTEM

1NZ-FXE ENGINE CONTROL SYSTEM > SERVICE DATA



Camshaft timing oil control valve
- Standard resistance
Terminals 1 - 2
at 20°C (68°F)
-
6.9 to 7.9 Ω
Camshaft position sensor
- Standard resistance
Terminals 1 - 2
Cold
The terms "Cold" and "Hot" refer to the temperature of the sensor. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).
1,630 to 2,740 Ω
Terminals 1 - 2
Hot
2,065 to 3,225 Ω
Crankshaft position sensor
- Standard resistance
Terminals 1 - 2
Cold
The terms "Cold" and "Hot" refer to the temperature of the sensor. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).
985 to 1,600 Ω
Terminals 1 - 2
Hot
1,265 to 1,890 Ω
Engine coolant temperature sensor
- Standard resistance
Terminals 1 - 2
at 20°C (68°F)
-
2.32 to 2.59 Ω
Terminals 1 - 2
at 80°C (176°F)
-
0.310 to 0.326 Ω
Throttle body (throttle control motor)
- Standard resistance
Terminals 1 - 2
at 25 °C (77°F)
-
50 MΩ or more
Throttle body (throttle position sensor)
- Standard resistance
Terminals 1 - 4
at 25 °C (77°F)
-
1.2 to 3.5 kΩ
Knock sensor
- Standard resistance
Terminals 1 - 2
at 20°C (68°F)
-
120 to 280 kΩ
EFI relay
- Standard resistance
Terminals 3I-5 - 3I-8
-
10 kΩor higher
Terminals 3I-5 - 3I-8
When battery voltage is applied to terminals 3I-6 and 3I-7)
Below 1 Ω
Circuit opening relay
- Standard resistance
Terminals 3G-5 - 3G-8
-
10 kΩ or higher
Terminals 3G-5 - 3G-8
When battery voltage is applied to terminals 3G-6 and 3G-7)
Below 1 Ω