Home › SERVICE SPECIFICATIONS › SERVICE SPECIFICATIONS › SUSPENSION

SUSPENSION > SERVICE DATA



Front wheel alignment
Vehicle height
A-B:
D-C:
95 mm (3.74 in.)
62 mm (2.40 in.)
Toe-in (total)
Rack end length difference
0° +-12' (0° +-0.2°, 0 +-2 mm, 0 +-0.08 in.)
1.5 mm (0.059 in.) or less
Wheel angle
Inside wheel
40° 35' +-2°
(40.58° +-2°)
Outside wheel: Reference
34°15'
(34.25°)
Camber
Right-left error
-0° 35' +-45' (-0.58° +-0.75°)
45' (0.75°) or less
Caster
Right-left error
3°10' +-45' (3.17° +-0.75°)
45' (0.75°) or less
Steering axis inclination
Right-left error
12°35' +-45' (12.58° +-0.75°)
45' (0.75°) or less
Rear wheel alignment
Toe-in (total)
0°18' +-15' (0.30° +-0.25°, 3.0 +-2.5 mm, 0.12 +-0.10 in.)
Camber
Right-left error
-1°30' +-30' (-1.50 +-0.5°)
30' (0.5°) or less
Front suspension
Lower ball joint turning torque
0.98 to 4.90 N*m (10 to 50 kgf*cm, 8.7 to 43 in.*lbf)
Stabilizer link turning torque
0.05 to 1.96 N*m (0.5 to 20 kgf*cm, 0.4 to 17.4 in.*lbf)

A:
Ground clearance of front wheel center

B:
Ground clearance of lower arm No.1 set bolt center

C:
Ground clearance of rear axle carrier bush set bolt center

D:
Ground clearance of rear wheel center