Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/ Smart Key System)

DTC    B2799-539    Engine Immobiliser System Malfunction

DTC    B2799-540    Engine Immobiliser System Malfunction

DTC    B2799-541    Engine Immobiliser System Malfunction

DTC    B2799-542    Engine Immobiliser System Malfunction

DTC    B2799-543    Engine Immobiliser System Malfunction

DTC    B2799-544    Engine Immobiliser System Malfunction

for Preparation Click here


DESCRIPTION

These DTCs are detected when: 1) the wire harness between the transponder key ECU and hybrid vehicle control ECU is open or shorted, 2) the ECU communication IDs of the hybrid vehicle control ECU and transponder key ECU are different, 3) the start ON (READY) signal is delayed, or 4) the key codes are unmatched.
Before troubleshooting for these DTCs, make sure no transponder key ECU DTCs are present. If present, troubleshoot the transponder key ECU DTCs or hybrid vehicle control ECU DTCs first.

DTC No.
DTC Detection Condition
Trouble Area
B2799-539
B2799-540
B2799-541
B2799-542
B2799-543
B2799-540
When any of the following conditions are met:
  1. Wire harness between transponder key ECU and hybrid vehicle control ECU is open or short
  2. ECU communication IDs of hybrid vehicle control ECU and transponder key ECU are different
  3. ON (READY) signal is delayed more than 10 seconds from when power switch is turned to ON (READY)
  4. Key codes are unmatched
  1. Wire harness
  2. Transponder key ECU
  3. Hybrid vehicle control ECU

WIRING DIAGRAM


B121684E21


INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Delete the DTC (Click here).

  1. Check that no DTC is output.

    OK:
    DTC is not output.



OK
END
NG


2.CHECK WIRE HARNESS (TRANSPONDER KEY ECU - HYBRID VEHICLE CONTROL ECU)


    B126103E01
  1. Disconnect the T5 and H14 ECU connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T5-19 (HEV0) - H14-18 (IMI)
    Below 1 Ω
    T5-18 (HEV1) - H14-26 (IMO)
    T5-19 (HEV0) or H14-18 (IMI) - Body ground
    10 kΩ or higher
    T5-18 (HEV1) or H14-26 (IMO) - Body ground



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK TRANSPONDER KEY ECU (OPERATION)
  1. Temporarily replace the transponder key ECU with a new or normally functioning one.

  1. Check that the power switch can be turned ON (ACC and IG) and the hybrid control system can be started.

    OK:
    Power switch can be turned ON (ACC and IG) and hybrid control system can be started.



NG
REPLACE HYBRID VEHICLE CONTROL ECU
OK

END (TRANSPONDER KEY ECU IS DEFECTIVE)