Home › BODY ELECTRICAL › AUDIO / VISUAL › INSTRUMENT PANEL SPEAKER

INSTRUMENT PANEL SPEAKER > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FRONT STEREO COMPONENT SPEAKER

HINT:
Remove interior parts so that the front stereo component speaker can be seen.

  1. Check the speaker installation.

    OK:
    The speaker is securely installed.

    If the result is not as specified, reinstall the front stereo component speaker.

  1. Visually check the speaker.

    OK:
    The cone paper of the speaker is not torn.

    If the result is not as specified, replace the front stereo component speaker.



  1. Speaker resistance check



      E116557
    1. Disconnect the front stereo component speaker connector.

    2. Measure the resistance between the terminals of the speaker.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 - 2
      1.2 to 2.2 Ω

      If the result is not as specified, replace the front stereo component speaker.