Home › BODY ELECTRICAL › AUDIO / VISUAL › STEERING PAD SWITCH

STEERING PAD SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STEERING PAD SWITCH ASSEMBLY


  1. Disconnect the steering pad switch assembly.


    E126427E05

  1. Measure the resistance of the wire side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    10 (AU1) - 8 (EAU)
    No switch is pushed
    Approx. 100 kΩ
    10 (AU1) - 8 (EAU)
    SEEK+ switch is pushed
    Below 2.5 Ω
    10 (AU1) - 8 (EAU)
    SEEK- switch is pushed
    Approx. 320 Ω
    10 (AU1) - 8 (EAU)
    VOL+ switch is pushed
    Approx. 1 kΩ
    10 (AU1) - 8 (EAU)
    VOL- switch is pushed
    Approx. 3.2 kΩ
    9 (AU2) - 8 (EAU)
    No switch is pushed
    Approx. 100 kΩ
    9 (AU2) - 8 (EAU)
    MODE switch is pushed
    Below 2.5 Ω
    9 (AU2) - 8 (EAU)
    VOICE switch is pushed
    3,110 Ω
    9 (AU2) - 8 (EAU)
    ON HOOK switch is pushed
    329 Ω
    9 (AU2) - 8 (EAU)
    OFF HOOK switch is pushed
    1,000 Ω
    3 (AC1) - 7 (EAC)
    No switch is pushed
    30 kΩ or higher
    3 (AC1) - 7 (EAC)
    INFO switch is pushed
    3,062 Ω
    2 (AC2) - 7 (EAC)
    No switch is pushed
    30 kΩ or higher
    2 (AC2) - 7 (EAC)
    MAP switch is pushed
    3,062 Ω

    If the resistance is not as specified, replace the steering pad switch assembly.