Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS › 2012.03–2019.03
BM2070E _V1 General _061965 INTRODUCTION _0301961 WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS  REPAIR PROCEDURE OF HEADLIGHT ASSEMBLY  


HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

If the installation area of the headlight assembly is damaged, use the supply retainer for low-cost repair.

·

Ensure that the headlight assembly is not damaged.



INSTALL UPPER HEADLIGHT PROTECTOR RETAINER


a.
E228268

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E228269

Install the upper headlight protector retainer with the 2 screws.



INSTALL UPPER NO. 2 HEADLIGHT PROTECTOR RETAINER


a.
E228270

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the upper No. 2 headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E228271

Install the upper No. 2 headlight protector retainer with the 2 screws.



REMOVE UPPER HEADLIGHT PROTECTOR RETAINER LH


a.
E253902

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the upper headlight protector retainer LH against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E253903

Install the upper headlight protector retainer LH with the 2 screws.



INSTALL LOWER HEADLIGHT PROTECTOR RETAINER


a.
E228272

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E228273

Install the lower headlight protector retainer with the 2 screws.



INSTALL LOWER NO. 2 HEADLIGHT PROTECTOR RETAINER


a.
E227599

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the lower No. 2 headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E227600

Install the lower No. 2 headlight protector retainer with the 2 screws.