Home › Vehicle Exterior › BODY PANEL › REAR FLOOR SIDE MEMBER
BM2070E _01 Vehicle Exterior _061966 BODY WELD POINT _0301985 REAR FLOOR SIDE MEMBER F

BODY WELD POINT  REAR FLOOR SIDE MEMBER  ASSEMBLY REPLACEMENT  


K101043

With the body lower back panel removed.


REMOVAL


Symbol meaning
K108818

Remove Weld Points
K108820

Remove Weld Points


U155301E02
0.219,0.146 0.604,0.5 0.385,0.354 12 false LH: 3.729,5.521 3.833,5.677 0.104,0.156 10 false 3 4.969,6.552 5.073,6.708 0.104,0.156 10 false 3 3.875,8.198 3.979,8.354 0.104,0.156 10 false 3 0.948,0.573 1.042,0.729 0.094,0.156 10 false 8 2.927,0.583 3.021,0.74 0.094,0.156 10 false 2 4.156,2.479 4.25,2.635 0.094,0.156 10 false 2 2.719,3.656 2.813,3.813 0.094,0.156 10 false 8

U155302E02
0.24,0.177 0.615,0.531 0.375,0.354 12 false RH: 5.333,6.333 5.438,6.49 0.104,0.156 10 false 4 6.625,5.135 6.729,5.292 0.104,0.156 10 false 3 0.646,8.302 0.75,8.458 0.104,0.156 10 false 3 3.406,0.646 3.5,0.802 0.094,0.156 10 false 7 1.865,0.667 1.958,0.823 0.094,0.156 10 false 2 0.75,3.604 0.844,3.76 0.094,0.156 10 false 2 2.094,3.823 2.271,3.979 0.177,0.156 10 false 10

INSTALLATION


Symbol meaning
K108823

Plug Weld
K108825

Plug Weld
K108835

Assembly Mark


INSTALLATION POINT
1.

For positioning of the new parts, align the installation standard holes of the rear floor side rear member and the member.

2.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

3.

After welding, apply undercoating to the corresponding parts. (See the painting / coating)

4.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K140505E01
3.188,4.51 3.375,4.51 3.375,4.51 5.229,5.365 false 0.198,0.177 0.542,0.417 0.344,0.24 12 false LH: 0.833,4.417 3.229,4.646 2.396,0.229 10 false REAR FLOOR SIDE MEMBER REAR

K140506E01
3.063,4.875 3.99,4.875 false 0.26,0.135 0.615,0.375 0.354,0.24 12 false RH: 0.698,4.781 3.063,5.01 2.365,0.229 10 false REAR FLOOR SIDE MEMBER REAR