Home › Vehicle Exterior › BODY PANEL › ROOF PANEL (w/o Glass Roof) › 2012.03–2019.03
BM2070E _01 Vehicle Exterior _061966 BODY WELD POINT _0301986 ROOF PANEL(w/o Glass Roof) F

BODY WELD POINT  ROOF PANEL(w/o Glass Roof)  ASSEMBLY REPLACEMENT  


K101048

REMOVAL


Symbol meaning
K108818

Remove Weld Points
K108820

Remove Weld Points


U155305E01
3.695,8.271 3.799,8.423 0.104,0.152 10 8 2.729,8.271 2.832,8.423 0.104,0.152 10 5 4.634,8.271 4.738,8.423 0.104,0.152 10 5 6.363,6.898 6.466,7.050 0.104,0.152 10 5 1.065,6.89 1.169,7.041 0.104,0.152 10 5 3.631,5.592 3.734,5.744 0.104,0.152 10 7 1.256,3.716 1.360,3.868 0.104,0.152 10 6 1.268,1.811 1.372,1.963 0.104,0.152 10 6 1.971,8.27 2.070,8.423 0.098,0.152 10 2 5.418,8.27 5.516,8.423 0.098,0.152 10 2 3.593,1.003 3.771,1.155 0.178,0.152 10 31 3.593,4.496 3.771,4.648 0.178,0.152 10 31 1.133,2.78 1.311,2.932 0.178,0.152 10 12

INSTALLATION


Symbol meaning
K108821

Spot Weld
K108823

Plug Weld
K108825

Plug Weld
K108834

Body Sealer


INSTALLATION POINT
1.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

2.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

3.

Before temporarily installing the new parts, apply body sealer to the windshield header panel, roof panel reinforcement and back door opening frame.

HINT:

Apply just enough body sealer for the new parts to make contact.


4.

After the roof panel reinforcement is welded to the new parts, install the roof panel to the vehicle side.

5.

After welding, apply body sealer to the corresponding parts. (See the painting / coating)

6.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K101050

K140507E01
4.656,5.156 4.49,5.156 4.49,5.156 4.49,4.021 false 4.719,5.063 5.667,5.26 0.948,0.198 10 false ROOF PANEL