Home › Vehicle Exterior › BODY DIMENSIONS › FRONT SUSPENSION CROSSMEMBER
BM2070E _01 Vehicle Exterior _061967 BODY DIMENSIONS _0301999 FRONT SUSPENSION CROSSMEMBER F

BODY DIMENSIONS  FRONT SUSPENSION CROSSMEMBER  TWO-DIMENSIONAL DISTANCE  


HINT:
·

Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.

·

Point C, c on the vehicle are asymmetrical.

·

In cases in which only one dimension is given, left and right are symmetrical.


·

For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).



Measuring Point Name
Symbol Name Hole Diameter
mm (in.)
A, a Front Suspension Lower Arm Installation Hole φ17.5 (0.69)
B, b Front Suspension Crossmember Installation Hole (Lower) φ22 (0.87)
C, c Front Suspension Crossmember Standard Hole φ12 (0.47)
D, d Steering Gear Box Installation Hole φ17 (0.67)
E, e Front Suspension Lower Arm Installation Hole 21X18.5 (0.83X0.73)
F, f Front Suspension Crossmember Installation Hole φ22 (0.87)

K140541E01
3.542,2.188 3.854,2.385 0.313,0.198 10 false FR 2.698,2.979 3.01,3.177 0.313,0.198 10 false LH 4.385,2.979 4.698,3.177 0.313,0.198 10 false RH 0.198,8.385 0.51,8.583 0.313,0.198 10 false mm 0.208,8.542 0.51,8.771 0.302,0.229 10 false (in.)

K140542E01
2.083,5.344 3.479,5.573 1.396,0.229 10 false Imaginary Datum Line 1.302,6.188 4.271,6.396 2.969,0.208 10 false Distance between points other than those above 0.198,8.385 0.51,8.583 0.313,0.198 10 false mm 0.208,8.542 0.479,8.771 0.271,0.229 10 false (in.)