Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS › from 2019.03
BM2070E _V1 General _061965 INTRODUCTION _0301961 WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS  PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED / RECONNECTED  


PROCEDURES NECESSARY WHEN AUXILIARY BATTERY TERMINAL IS DISCONNECTED/RECONNECTED


Necessary Procedures Effect / Inoperative Function When Necessary Procedures are not Performed
Perform steering sensor zero point calibration Lane Departure Alert System (w/ Steering Control)
Pre-crash Safety System
Intelligent Parking Assist System
Back door lock Power Door Lock Control System

NOTICE:
·

After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 90 seconds*1 or 120 seconds*2*4 before disconnecting the cable from the negative (-) auxiliary battery terminal.

·

After the power switch is turned off, the navigation receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 90 seconds*3 before disconnecting the cable from the negative (-) auxiliary battery terminal.


*1: w/ Audio and Visual System (for Toyota Link Function)

*2: w/ Audio and Visual System (for DAB Function)

*3: w/ Navigation System (for Navigation Receiver Type)

*4: w/ Navigation System (for Radio and Display Type)