Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS › from 2019.03
BM2070E _V1 General _061965 INTRODUCTION _0301961 WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS  REPAIR PROCEDURE OF HEADLIGHT ASSEMBLY  


HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

If the installation area of the headlight assembly is damaged, use the supply retainer for low-cost repair.

·

Ensure that the headlight assembly is not damaged.



INSTALL UPPER HEADLIGHT PROTECTOR RETAINER


a.
E308107

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E308108

Install the upper headlight protector retainer with the 2 screws.



INSTALL UPPER NO. 2 HEADLIGHT PROTECTOR RETAINER


a.
E308109

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the upper No. 2 headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E308110

Install the upper No. 2 headlight protector retainer with the 2 screws.



INSTALL UPPER HEADLIGHT PROTECTOR RETAINER LH (for Halogen Headlight)


a.
E308120

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the upper headlight protector retainer LH against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E308103

Install the upper headlight protector retainer LH with the 2 screws.



INSTALL UPPER HEADLIGHT PROTECTOR RETAINER LH (for LED Headlight)


a.
E308111

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the upper headlight protector retainer LH against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E308112

Install the upper headlight protector retainer LH with the 2 screws.



INSTALL LOWER HEADLIGHT PROTECTOR RETAINER (for Halogen Headlight)


a.
E308121

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E308104

Install the lower headlight protector retainer with the 2 screws.



INSTALL LOWER HEADLIGHT PROTECTOR RETAINER (for LED Headlight)


a.
E308113

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E308114

Install the lower headlight protector retainer with the 2 screws.



INSTALL LOWER NO. 2 HEADLIGHT PROTECTOR RETAINER (for Halogen Headlight)


a.
E308105

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the lower No. 2 headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E308106

Install the lower No. 2 headlight protector retainer with the 2 screws.



INSTALL LOWER NO. 2 HEADLIGHT PROTECTOR RETAINER (for LED Headlight)


a.
E311333

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the lower No. 2 headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E311334

Install the lower No. 2 headlight protector retainer with the 2 screws.