OUTLINE
The dynamic radar cruise control system has 2 cruise control modes: Constant Speed Control Mode, and Vehicle-to-vehicle Distance Control Mode.
The cruise control switch is used for switching between the 2 modes. The mode in which the cruise control system starts is vehicle-to-vehicle distance control mode.
| Mode | Outline |
|---|---|
| Constant Speed Control Mode | Constant speed control mode is the same as in the conventional (non-dynamic radar type) cruise control system. However, differences are as follows: -
The conventional cruise control system has the lowest settable vehicle speed limit: approximately 40 km/h (25 mph) versus approximately 50 km/h (30 mph) for dynamic radar cruise control system (constant speed control mode). |
| Vehicle-to-vehicle Distance Control Mode | In vehicle-to-vehicle distance control mode, the system detects and recognizes a preceding vehicle. Thus, the system is able to maintain the proper vehicle-to-vehicle distance in accordance with the vehicle speed, and allows the vehicle to be driven under follow-up control. -
The driver can operate the distance control switch on the steering wheel to select the vehicle-to-vehicle distance in 3 levels: long, middle, and short. -
This mode consists mainly of 4 controls: constant speed control, deceleration control, follow-up control, and acceleration control. |
In vehicle-to-vehicle distance control mode, the illustrations below show control examples while the driver's own vehicle is operating at 100 km/h (62 mph), and the vehicle ahead is operating at 80 km/h (50 mph).
| *a | Constant Speed Control | *b | Deceleration Control |
| *c | Follow-up Control | *d | Acceleration Control |
| *e | 100 km/h (62 mph) | *f | From 100 km/h (62 mph) to 80 km/h (50 mph) |
| *g | 80 km/h (50 mph) | *h | From 80 km/h (50 mph) to 100 km/h (62 mph) |