Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM › 2012.03–2016.05
NM2070E _57 Power Source / Network _061884 NETWORKING _0301426 CAN COMMUNICATION SYSTEM UN GENERAL/CONTROL/DETAILS F

NETWORKING  CAN COMMUNICATION SYSTEM  GENERAL/CONTROL/DETAILS  DETAILS  


DIAGNOSIS


a.

If a malfunction is detected on the CAN communication bus, ECUs that are connected to the CAN communication bus store the Diagnostic Trouble Code (DTC) in memory.


b.

The 5-digit DTCs can be read after connecting the Global TechStream (GTS) to DLC3.


c.

DLC3 is equipped with a CAN-H and a CAN-L terminal on the V bus to allow CAN diagnosis. It is possible to determine if there is an open or short in the main wires of the V bus by measuring the resistance value between these terminals.


d.

For details, refer to the Repair Manual.