Home › Engine / Hybrid System › 2ZR-FXE LUBRICATION › LUBRICATION SYSTEM › from 2017.12
NM2070E _51 Engine / Hybrid System _061865 2ZR-FXE LUBRICATION _0301401 LUBRICATION SYSTEM UN GENERAL/CONTROL/DETAILS F

2ZR-FXE LUBRICATION  LUBRICATION SYSTEM  GENERAL/CONTROL/DETAILS  DETAILS  


CONSTRUCTION


a.

Oil Pump Assembly

i.

The trochoidal type oil pump assembly is driven by the crankshaft, and fits compactly inside the oil pan.


ii.

A relief valve has been provided on the oil pump assembly, thus, any excessive pressure rises are restrained and friction loss is reduced.

Models with Element Kit Type Oil Filter
W101576C04
4,1.688 5.198,0.448 5.198,0.448 5.302,0.448 true 3.958,2.938 5.406,2.271 5.406,2.271 5.521,2.271 true 3.406,2.552 1.583,1.688 1.583,1.688 1.458,1.688 true 5.354,0.375 5.708,0.688 0.354,0.313 10 false *1 5.563,2.198 5.917,2.51 0.354,0.313 10 false *3 1.271,1.625 1.625,1.938 0.354,0.313 10 false *2
*1 Crankshaft *2 Oil Pump Assembly
*3 Relief Valve - -


Models with Cartridge Type Oil Filter
W137968C01
4,1.667 4.917,1.167 4.917,1.167 5.25,1.167 true 3.917,2.917 4.833,2.417 4.833,2.417 5.167,2.417 true 1.5,1.917 1.833,1.917 1.833,1.917 3.333,2.583 true 5.292,1.073 5.521,1.292 0.229,0.219 10 false *1 1.302,1.813 1.5,2.031 0.198,0.219 10 false *2 5.219,2.323 5.438,2.521 0.219,0.198 10 false *3
*1 Crankshaft *2 Oil Pump Assembly
*3 Relief Valve - -




b.

No. 1 Oil Nozzle Sub-assembly

i.

No. 1 oil nozzle sub-assemblies for cooling and lubricating the pistons are provided in the cylinder block sub-assembly.


ii.

These No. 1 oil nozzle sub-assemblies contain a check ball to prevent oil from being fed when the oil pressure is low. This prevents the overall oil pressure in the engine from dropping.

W101577C03
1.771,2.365 2,3.188 2,3.188 2.094,3.188 true 1.625,1.115 1.406,0.5 1.406,0.5 1.313,0.5 false 5.698,1.948 6.177,2.563 6.177,2.563 6.26,2.563 true 1.125,0.427 1.313,0.625 0.188,0.198 10 false *1 6.292,2.51 6.51,2.708 0.219,0.198 10 false *3 5.625,2.667 5.844,2.865 0.219,0.198 10 false *a 2.146,3.115 2.333,3.313 0.188,0.198 10 false *2
*1 Cylinder Block Sub-assembly *2 No. 1 Oil Nozzle Sub-assembly
*3 Check Ball - -
*a No. 1 Oil Nozzle Sub-assembly Cross Section - -
V100135

Oil - -




c.

Oil Filter Element (Models with Element Kit Type Oil Filter)

i.

A replaceable oil filter element is used. The oil filter element uses a high-performance filter paper to improve filtration performance. It is also combustible for environmental protection.

W101578C03
4.813,2.104 5.344,2.688 5.344,2.688 5.406,2.688 false 3.656,2.906 3.969,3.427 3.969,3.427 4.042,3.427 false 2.917,3.052 2.573,3.594 2.573,3.594 2.5,3.594 false 2.063,3.021 1.646,3.323 1.646,3.323 1.573,3.323 true 5.5,2.625 5.823,2.833 0.323,0.208 10 false *1 4.063,3.385 4.385,3.594 0.323,0.208 10 false *2 2.292,3.521 2.615,3.729 0.323,0.208 10 false *3 1.365,3.24 1.688,3.448 0.323,0.208 10 false *4
*1 Oil Filter Bracket Sub-assembly *2 Oil Filter Element
*3 O-ring *4 Oil Filter Cap Assembly


HINT:

The engine oil maintenance interval for a model that has an oil filter with a replaceable oil filter element is the same as that for a conventional model.