Home › Engine / Hybrid System › 2ZR-FXE (ENGINE MECHANICAL) › ENGINE UNIT › 2019.03–2020.08
NM2070E _51 Engine / Hybrid System _061860 2ZR-FXE ENGINE MECHANICAL _0301395 ENGINE UNIT UN GENERAL/CONTROL/DETAILS F

2ZR-FXE ENGINE MECHANICAL  ENGINE UNIT  GENERAL/CONTROL/DETAILS  GENERAL  


OUTLINE


a.

The 2ZR-FXE engine is an in-line, 4-cylinder, 1.8-liter, 16-valve DOHC engine.


b.

This engine uses a high-expansion ratio Atkinson cycle, Variable Valve Timing-intelligent (VVT-i) system, Direct Ignition System (DIS), Electronic Throttle Control System-intelligent (ETCS-i) and Exhaust Gas Recirculation (EGR) system employing a highly efficient EGR cooler. In addition, use of an electric water pump has enhanced warm-up performance and reduced cooling losses. Thus, improved engine performance, quietness, fuel economy, and cleaner emissions have been achieved.

W101520



SPECIFICATION


Engine Type 2ZR-FXE

*1: Similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, and non-borate coolant with long-life hybrid organic acid technology (coolant with long-life hybrid organic acid technology is a combination of low phosphates and organic acids).

*2: The figure shown is the weight of the engine with coolant and oil.

*3: Cold area specification models

*4: Emission regulations differ by country and region.

Combustion Chamber Pentroof Type
Flow of Intake and Exhaust Gasses Cross-flow
Fuel System SFI
Ignition System DIS
Displacement cm3 (cu. in.) 1798 (109.7)
Bore x Stroke mm (in.) 80.5 X 88.3 (3.17 X 3.48)
Compression Ratio 13.0 : 1
Max. Output (EEC) kW@rpm 73@5200
Max. Torque (EEC) N*m@rpm 142@2800 to 4400
Valve Timing Intake Open 29° BTDC to 12° ATDC
Close 61° ABDC to 102° ABDC
Exhaust Open 31° BBDC
Close 3° ATDC
Oil Capacity Dry liters (US qts, Imp. qts) 4.7 (5.0, 4.1)
With Oil Filter liters (US qts, Imp. qts) 4.2 (4.4, 3.7)
Without Oil Filter liters (US qts, Imp. qts) 3.9 (4.1, 3.4)
Oil Grade API grade SL "Energy-Conserving", SM "Energy-Conserving", SN "Resource-Conserving" or ILSAC
Engine Coolant Type TOYOTA Genuine Super Long Life Coolant or the following*1
Capacity liters (US qts, Imp. qts) 6.5 (6.9, 5.7)
6.9 (7.3, 6.1)*3
Spark Plug Type DENSO Made SC16HR11/SC20HR11 (Iridium)
Plug Gap mm (in.) 1.0 to 1.1 (0.0394 to 0.0433)
Firing Order 1 - 3 - 4 - 2
Research Octane Number 95 or higher
Emission Regulation*4 EURO 6d-TEMP
EURO 5
Engine Service Mass*2 (Reference) kg (lb) 90 (198)

W101584E07
5.333,0.5 5.573,0.708 0.24,0.208 10 false 80 1.542,0.635 1.833,0.844 0.292,0.208 10 false 160 1.542,1.083 1.833,1.292 0.292,0.208 10 false 150 1.542,1.5 1.833,1.708 0.292,0.208 10 false 140 1.542,1.958 1.833,2.167 0.292,0.208 10 false 130 1.542,2.417 1.833,2.625 0.292,0.208 10 false 120 1.542,2.844 1.833,3.052 0.292,0.208 10 false 110 1.542,3.292 1.833,3.5 0.292,0.208 10 false 100 5.333,0.875 5.573,1.083 0.24,0.208 10 false 70 5.333,1.25 5.573,1.458 0.24,0.208 10 false 60 5.333,1.625 5.573,1.833 0.24,0.208 10 false 50 5.333,2 5.573,2.208 0.24,0.208 10 false 40 5.333,2.375 5.573,2.583 0.24,0.208 10 false 30 5.333,2.75 5.573,2.958 0.24,0.208 10 false 20 5.333,3.125 5.573,3.333 0.24,0.208 10 false 10 5.333,3.458 5.573,3.667 0.24,0.208 10 false 0 2.083,3.833 2.458,4.052 0.375,0.219 10 false 1000 2.625,3.833 3,4.052 0.375,0.219 10 false 2000 3.167,3.833 3.542,4.052 0.375,0.219 10 false 3000 3.667,3.833 4.042,4.052 0.375,0.219 10 false 4000 4.208,3.833 4.583,4.052 0.375,0.219 10 false 5000 4.708,3.833 5.083,4.052 0.375,0.219 10 false 6000 5.26,0.25 5.583,0.521 0.323,0.271 10 false kW 1.552,0.323 2,0.583 0.448,0.26 10 false N*m 1,1.917 1.479,2.281 0.479,0.365 10 false Torque 5.688,1.885 6.167,2.25 0.479,0.365 10 false Output 2.917,4.083 4.208,4.396 1.292,0.313 10 false Engine Speed (rpm) 2.938,4.396 4.167,4.708 1.229,0.313 10 false Performance Curve


MAIN FEATURES


a.

The 2ZR-FXE engine has achieved the following through the use of the items listed in the table below.

i.

High performance and reliability


ii.

Low noise and vibration


iii.

Lightweight and compact design


iv.

Good serviceability


v.

Clean emissions and fuel economy

Item i ii iii iv v
The high-expansion ratio Atkinson cycle is adopted. ○
Engine Proper An aluminum cylinder block sub-assembly is used. ○
An offset crankshaft is used. ○ ○ ○
Spiny type liners are used. ○
The taper squish shape is used for the top of the pistons. ○ ○
The skirt portion of the piston has a resin coating applied to reduce friction. ○ ○ ○
Low-tension piston rings are used. ○ ○
Valve Mechanism A timing chain sub-assembly and chain tensioner assembly are used. ○ ○
Hydraulic valve lash adjuster assemblies are used. ○ ○
Roller No. 1 valve rocker arm sub-assemblies are used. ○ ○
The Variable Valve Timing-intelligent (VVT-i) system is used. ○ ○
Intake and Exhaust System A plastic intake manifold is used. ○
A linkless type throttle body assembly is used. ○ ○
A DC motor type Exhaust Gas Recirculation (EGR) valve is used. ○ ○
A water-cooled type Exhaust Gas Recirculation (EGR) cooler is used. ○ ○
A stainless steel exhaust manifold is used. ○
Three-Way Catalytic converters (TWCs) are used. ○
A 2-way exhaust control system is used. ○ ○
Fuel System 12-hole type fuel injector assemblies are used. ○ ○
A fuel returnless system is used. ○ ○
Quick connectors are used to connect the fuel hoses and fuel pipes. ○
Cooling System An electric engine water pump assembly is used. ○
Ignition System A Direct Ignition System (DIS) is used. ○ ○ ○ ○
Long-reach type iridium-tipped spark plugs are used. ○ ○ ○
Engine Control System The Electronic Throttle Control System-intelligent (ETCS-i) is used. ○ ○
A Magneto-Resistance Element (MRE) type cam position sensor is used. ○
A flat type knock control sensor is used. ○