Home › Engine / Hybrid System › 2ZR-FXE (ENGINE CONTROL) › SFI SYSTEM
RM2070E _51 Engine / Hybrid System _061905 2ZR-FXE ENGINE CONTROL _0301559 SFI SYSTEM D

2ZR-FXE ENGINE CONTROL  SFI SYSTEM  CHECK MODE PROCEDURE  


HINT:

Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect malfunctions that cannot be detected in normal mode.


NOTICE:

All the stored DTCs and freeze frame data are cleared if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the power switch is turned from on (IG) to on (ACC) or off while in check mode. Before changing modes, always check and note any DTCs and freeze frame data.


CHECK MODE PROCEDURE


a.

Check and ensure the following conditions:

i.

Auxiliary battery voltage is 11 V or higher.


ii.

Accelerator pedal fully released.


iii.

Park (P) or neutral (N) selected.


iv.

A/C switch is off.



b.

Turn the power switch off.


c.

Connect the GTS to the DLC3.


d.

Turn the power switch on (IG).


e.

Turn the GTS on.


f.

Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode.


g.

Switch the ECM from normal mode to check mode.


h.
A076900E60
2.042,0.417 2.948,0.646 0.906,0.229 10 false 0.13 seconds 1.917,1.833 3.427,2.177 1.51,0.344 10 true 0.13 seconds 0.135,0.76 0.427,0.958 0.292,0.198 10 false ON 0.135,1.385 0.427,1.583 0.292,0.198 10 false OFF

Check that the MIL flashes as shown in the illustration.


i.

Turn the power switch on (READY).


j.

Check that the MIL turns off.


k.

Simulate the conditions of the malfunction described by the customer.


l.

Check the DTCs and freeze frame data using the GTS.