Home › Engine / Hybrid System › 2ZR-FXE (ENGINE CONTROL) › THROTTLE BODY › from 2014.11
RM2070E _51 Engine / Hybrid System _061905 2ZR-FXE ENGINE CONTROL _0301562 THROTTLE BODY G

2ZR-FXE ENGINE CONTROL  THROTTLE BODY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 22210 1.INSPECT THROTTLE BODY ASSEMBLY

a.

Set the vehicle to inspection mode (See page General>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE).


b.

Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range when the A/C is switched off.

Standard:
Condition Engine Idle Speed
A/C switched off 950 to 1050 rpm


NOTICE:
·

Be sure to perform this step with all accessories off.

·

Make sure that park (P) is selected.