Home › Engine / Hybrid System › 2ZR-FXE (ENGINE CONTROL) › ECM › 2012.03–2013.08
RM2070E _51 Engine / Hybrid System _061905 2ZR-FXE ENGINE CONTROL _0301563 ECM A

2ZR-FXE ENGINE CONTROL  ECM  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


HV battery learning values are stored in the power management control ECU and ECM to illuminate the hybrid battery indicator light in the combination meter assembly. When either of these ECUs is replaced, the new ECU receives the HV battery learning value data from the other ECU and updates the information.

NOTICE:
·

Do not replace the power management control ECU and ECM at the same time as it clears the HV battery learning values. However, if it is necessary to replace both ECUs at the same time, replace them by following the procedure below.

·

Do not replace the power management control ECU or ECM with used ones from other vehicles.



a.

Procedure when replacing both power management control ECU and ECM:

i.

Disconnect the cable from the negative (-) auxiliary battery terminal.


ii.

Replace either of the ECUs.


iii.

Connect the cable to the negative (-) auxiliary battery terminal.


iv.

Turn the power switch on (READY) and wait for 5 minutes or more.


v.

Turn the power switch off and disconnect the cable from the negative (-) auxiliary battery terminal.


vi.

Replace the other ECU.


vii.

Connect the cable to the negative (-) auxiliary battery terminal.


viii.

Check that the power switch can be turned on (READY).

HINT:

If the power management control ECU and ECM are replaced at the same time without following the above procedure, replace either of the ECUs with its original one and then replace it again by following the above procedure. If the correct procedure is not followed, perform the procedure again from the beginning.




Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide G9200 8.REMOVE INVERTER WITH CONVERTER ASSEMBLY

Hide G92A0A 9.SEPARATE INVERTER RESERVE TANK ASSEMBLY

a.
A212304

Remove the 2 bolts and separate the inverter reserve tank assembly.


Hide 89661 10.REMOVE ECM

a.

Remove the No. 1 relay block cover.


b.
A212300

Disconnect the 3 wire connectors.


c.
A212301

Disengage the 2 claws, push up the engine room wire harness and separate it from the engine room relay block.


d.
A212302

Disengage the 2 claws and push up the side cover to remove it.


e.
A212303

Loosen the bolt and separate the No. 2 engine room wire.


f.

Disconnect the 2 ECM connectors.

i.
A212305

Disconnect the 2 wire harness clamps.


ii.

Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.

NOTICE:

After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.




g.
A212306

Separate the 2 wire harness clamps.


h.
A212307

Remove the 2 bolts and ECM.