Home › Engine / Hybrid System › 2ZR-FXE (ENGINE CONTROL) › HEATED OXYGEN SENSOR › 2014.11–2016.05
RM2070E _51 Engine / Hybrid System _061905 2ZR-FXE ENGINE CONTROL _0301571 HEATED OXYGEN SENSOR A

2ZR-FXE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSTALLATION  


PROCEDURE

Hide 89465 1.INSTALL HEATED OXYGEN SENSOR

a.
A212296E09
1.813,1.667 2.688,0.438 2.688,0.438 2.833,0.438 false 0.979,3.792 1.156,3.958 0.177,0.167 10 false *a 3.031,2.292 3.271,2.583 0.24,0.292 10 true *b 2.917,0.375 3.229,0.688 0.313,0.313 10 false SST

Using SST, install the heated oxygen sensor onto the front exhaust pipe.

Text in Illustration
*a Fulcrum Length
30 mm
*b Fulcrum Length
300 mm

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

NOTICE:
·

The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.) and a torque wrench with a fulcrum length of 300 mm (11.8 in.) (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

The "with SST" torque value is effective when SST is parallel to the torque wrench.




b.

Connect the wire harness to install the wire harness clamp bracket.


c.

Install the wire harness clamp bracket with the bolt.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


d.

Install the wire harness bracket.


e.

Connect the heated oxygen sensor connector.


Hide 2.INSPECT FOR EXHAUST GAS LEAK

Hide 51442A 3.INSTALL FRONT NO. 3 ENGINE UNDER COVER

a.

Install the front No. 3 engine under cover with the 4 clips.