89465
1.INSTALL HEATED OXYGEN SENSOR
Using SST, install the heated oxygen sensor onto the front exhaust pipe.
| *a | Fulcrum Length
30 mm |
| *b | Fulcrum Length
300 mm |
The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.) and a torque wrench with a fulcrum length of 300 mm (11.8 in.) (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
The "with SST" torque value is effective when SST is parallel to the torque wrench.
Connect the wire harness to install the wire harness clamp bracket.
Install the wire harness clamp bracket with the bolt.
Install the wire harness bracket.
Connect the heated oxygen sensor connector.
2.INSPECT FOR EXHAUST GAS LEAK
51442A
3.INSTALL FRONT NO. 3 ENGINE UNDER COVER
Install the front No. 3 engine under cover with the 4 clips.