The hybrid vehicle control ECU monitors the IGCT relay and detects the following malfunction.
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P3110 | 223 | There is a short to +B in the IGCT relay or the IGCT relay is stuck closed. | ·
Wire harness or connector ·
IGCT relay ·
Hybrid vehicle control ECU |
If the auxiliary battery voltage is applied to terminal +B1 or +B2 of the hybrid vehicle control ECU, even though the power switch is off, the circuit is shorted to +B.
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
Turn the power switch on (IG) and wait for 15 seconds or more.
Turn the power switch off and wait for 30 seconds or more.
Remove the IGCT relay from the engine room relay block and junction block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Auxiliary battery voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| *1 | IGCT Relay |
Install the IGCT relay.
OK
NG
Remove the IGCT relay from the engine room relay block and junction block assembly.
Disconnect the A21 and A22 hybrid vehicle control ECU connectors.
Measure the voltage according to the value(s) in the table below.
| *1 | Engine Room Relay Block and Junction Block Assembly | *2 | IGCT relay |
| *a | Rear view of wire harness connector
(to Hybrid vehicle control ECU) |
- | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A22-4 (+B1), A21-1 (+B2) or 5 (IGCT relay) - Body ground | Power switch off | Below 1 V |
Install the IGCT relay.
Reconnect the A21 and A22 hybrid vehicle control ECU connectors.
OK
NG