Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM › 2012.03–2015.08
RM2070E _51 Engine / Hybrid System _061906 HYBRID / BATTERY CONTROL _0301573 HYBRID CONTROL SYSTEM D

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  OPERATION HISTORY DATA  


OPERATION HISTORY DATA


HINT:

The power management control ECU records inappropriate operations performed by the driver and the number of abnormal conditions that have been input to the ECU as operation history data.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Hybrid Control / Data List.


e.

Enter the menu to view the number of inappropriate operations or controls that have been performed.

HINT:
·

Latest Operation: Among the past occurrences, the number of inappropriate operations or controls that have been performed during the most recent 1 trip detection.

·

Latest Trip: The number of trips after the occurrence of Latest Operation.

·

Operation before Latest: The number of occurrences during the trip previous to the Latest Operation.

·

Trip before Latest: The number of trips after the occurrence of Operation before Latest.



Inappropriate Operation and History Data
Tester Display Count Condition
N Range Control by Busy Shift N position control performed due to frequent shifting operation
Step Accelerator in N Range Accelerator pedal depressed in N position
Auxiliary Battery Low Auxiliary battery voltage below 9.5 V
HV ECU Intermittent Problems Instantaneous open circuit at +B terminal of power management control ECU
MG2 (Motor) Temp High MG2 temperature exceeded 168°C (334°F)
MG1 (Generator) Temp High MG1 temperature exceeded 182°C (360°F)
MG2 (Motor) Inverter Temperature High Motor inverter temperature rose and HV system overheat was indicated
MG1 (Generator) Inverter Temperature High Generator inverter temperature rose and HV system overheat was indicated
Main Battery Low Voltage HV battery state of charge dropped below 30%
Resistor Over Heat Precharge resistor overheated
Coolant Heating HV coolant temperature exceeded 65°C (149°F)
Converter Heating Boost converter temperature rose and HV system overheat was indicated
Shift P in Running P position switch pushed while driving
Shift Backward Direction Shifted to R while moving forward or to D or B while moving in reverse
Prevention Control of Staying Engine speed stays in resonance frequency band
Accelerator and Brake Depressing Both accelerator and brake pedals depressed
Shift without Depressing Brake Shift lever moved without depressing brake pedal
Shift R or D during Ready OFF shifted to R or D during READY OFF operation