Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM › 2012.03–2012.10
RM2070E _51 Engine / Hybrid System _061906 HYBRID / BATTERY CONTROL _0301573 HYBRID CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  P06A4-209  Sensor Reference Voltage "D" Circuit Low  P06A5-210  Sensor Reference Voltage "D" Circuit High  


DESCRIPTION

The power management control ECU monitors voltage of 5 V power supply (VC) used for the sensors. If the power management control ECU detects a malfunction, it will set a DTC.

DTC No. INF Code DTC Detection Condition Trouble Area
P06A4 209 VC power-supply voltage is lower than 4.2 V Power management control ECU
P06A5 210 VC power-supply voltage is higher than 5.8 V

CAUTION / NOTICE / HINT

HINT:

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

1.

Turn the power switch on (IG) and wait for 15 seconds or more.



PROCEDURE

1.CHECK DTC OUTPUT (HYBRID CONTROL)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.


d.

Check if DTCs are output.

Result:
Result Proceed to
P06A4-209 or P06A5-210 only is output. A
Any of the following DTCs are also output. B


DTC No. Relevant Diagnosis
P0516-769 Battery Temperature Sensor Circuit Low
P0517-770 Battery Temperature Sensor Circuit High
P0A2C-247 Drive Motor "A" Temperature Sensor Circuit Low
P0A2D-249 Drive Motor "A" Temperature Sensor Circuit High
P0A38-257 Generator Temperature Sensor Circuit Low
P0A39-259 Generator Temperature Sensor Circuit High
P2120-152 Throttle/Pedal Position Sensor/Switch "D" Circuit
P2122-104 Throttle/Pedal Position Sensor/Switch "D" Circuit Low Input
P2123-105 Throttle/Pedal Position Sensor/Switch "D" Circuit High Input
P2125-153 Throttle/Pedal Position Sensor/Switch "E" Circuit
P2127-107 Throttle/Pedal Position Sensor/Switch "E" Circuit Low Input
P2128-108 Throttle/Pedal Position Sensor/Switch "E" Circuit High Input

HINT:

P06A4-209 or P06A5-210 may be set due to a malfunction which also causes DTCs in the preceding table to be set. In this case, first troubleshoot the output DTCs in the preceding table. Then, perform a test to attempt to reproduce the problems, and check that no DTCs are output.



e.

Turn the power switch off.



A

B