Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM › 2012.10–2014.11
RM2070E _51 Engine / Hybrid System _061906 HYBRID / BATTERY CONTROL _0301573 HYBRID CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  P1606-308  Collision has been detected or Collision Sensor Connection (Open)  P1606-317  Collision has been detected or Collision Sensor Connection (Open)  


DESCRIPTION

The power management control ECU receives a signal that indicates a collision from the airbag ECU assembly to detect a collision. After detecting a collision, the power management control ECU shuts off the high voltage systems for safety.

DTC No. INF Code DTC Detection Condition Trouble Area
P1606 308 Shutoff signal from the airbag ECU assembly is determined.
·

Airbag ECU assembly

·

Power management control ECU

·

Airbag systems


317 A collision is determined due to a wiring malfunction.
·

Power management control ECU

·

Airbag system



HINT:

If P1606-308 or 317 is output, the vehicle cannot start unless the DTCs are cleared using the GTS.


CAUTION / NOTICE / HINT

HINT:

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

1.

Turn the power switch on (IG) and wait for 5 seconds or more.



PROCEDURE

1.CHECK VEHICLE FOR COLLISION DAMAGE
a.

Check the vehicle condition.

Result:
Result Proceed to
The vehicle is not damaged. A
The vehicle is damaged. B




A

2.CHECK DTC OUTPUT (HYBRID CONTROL)

B

REPAIR VEHICLE

2.CHECK DTC OUTPUT (HYBRID CONTROL)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.


d.

Check if DTCs are output.

Result:
Result Proceed to
P1606 only is output. A
P0A1D is output. B



e.

Turn the power switch off.



A

3.CHECK AIRBAG SYSTEM

B

3.CHECK AIRBAG SYSTEM
a.

Troubleshoot the airbag system (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).

Result:
Result Proceed to
The system is normal. A
There is a malfunction in the system. B




A

4.CHECK INFORMATION CODE

B

REPAIR MALFUNCTIONING PARTS, COMPONENT AND AREA

4.CHECK INFORMATION CODE
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.


d.

Access the freeze frame data of DTC P1606 and read the INF code.

Result:
Result Proceed to
INF code 308 is output. A
INF code 317 is output. B



e.

Turn the power switch off.



A

B

5.CHECK DTC OUTPUT (HYBRID CONTROL)
5.CHECK DTC OUTPUT (HYBRID CONTROL)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.


d.

Check if DTCs are output.

Result:
Result Proceed to
One or two of the following conditions are met. A
All of the following conditions are met. B


DTC Output Status
1 DTC P3107-213 or P3107-214 is output.
2 DTC U0151-763 is output.
3 DTC U0110-160 or U0110-657 is output.


e.

Turn the power switch off.



A

B