Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM › 2012.03–2012.10
RM2070E _51 Engine / Hybrid System _061906 HYBRID / BATTERY CONTROL _0301573 HYBRID CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  P3004-133  High Voltage Power Resource  


DESCRIPTION

The power management control ECU monitors its internal operation, it will set DTCs and perform fail-safe control when it detects the following malfunctions.

DTC No. INF Code DTC Detection Condition Trouble Area
P3004 133 A high-voltage wiring system error signal is detected in the power management control ECU Power management control ECU

CAUTION / NOTICE / HINT

HINT:

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

1.

Drive the vehicle for approximately 10 minutes according to the freeze frame data items "Vehicle Spd", "Accelerator Degree" and "Power Resource IB".



PROCEDURE

1.CHECK DTC OUTPUT (HYBRID CONTROL)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.


d.

Check if DTCs are output.

Result:
Result Proceed to
P3004-133 only is output. A
DTCs other than P3004-133 is output. B



e.

Turn the power switch off.



A

B