The hybrid vehicle control ECU monitors its internal operation, it will set DTCs and perform fail-safe control when it detects the following malfunctions.
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P3004 | 133 | A high-voltage wiring system error signal is detected in the hybrid vehicle control ECU | Hybrid vehicle control ECU |
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
Drive the vehicle for approximately 10 minutes according to the freeze frame data items "Vehicle Spd", "Accelerator Degree" and "Power Resource IB".
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Check if DTCs are output.
| Result | Proceed to |
|---|---|
| P3004-133 only is output. | A |
| DTCs other than P3004-133 is output. | B |
Turn the power switch off.
A
B
(See pageEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART)