Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM › from 2014.11
RM2070E _51 Engine / Hybrid System _061906 HYBRID / BATTERY CONTROL _0301573 HYBRID CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  P0E33-589  DC/DC Converter Voltage Sensor "A" Low  P0E34-590  DC/DC Converter Voltage Sensor "A" High  


DESCRIPTION

The MG ECU uses a voltage sensor that is built into the boost converter to detect pre-boost high voltage (VL) to allow boost control. The MG ECU monitors the boost converter voltage sensor signal line and detects the following malfunctions.

DTC No. INF Code DTC Detection Condition Trouble Area
P0E33 589 Open or short to GND in the boost converter voltage (VL) sensor circuit Inverter with converter assembly
P0E34 590 Short to +B in the boost converter voltage (VL) sensor circuit

CAUTION / NOTICE / HINT

HINT:

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

1.

Turn the power switch on (IG) and wait for 5 seconds or more.



PROCEDURE

1.REFER TO REPLACE INVERTER WITH CONVERTER ASSEMBLY PARTS
a.

Refer to replace inverter with converter assembly parts (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DTC CHECK / CLEAR).


HINT:

The boost converter voltage (VL) sensor is connected to the MG ECU inside the inverter with converter assembly.



NEXT

COMPLETED